This 1990 Bertam Sportfisher with low hours on the repowered Yanmar diesels, brand new generator (under 10h), new Garmin GPS, hardtop flybridge with full enclosure is ready to take offshore.
-
Repowered Yanmar diesel engines (approx hours 300h)
-
Brand new Cummins Onan 9kw generator installed in 2022 (under 10h)
-
New GarminGPS map 7612xsv, 12 inch (2022)
-
Epirp and liferaft included
-
Amtico Teak & Holly Flooring (no carpet)
-
New Aluminum outriggers
-
Fiberglass Hardtop for flybridge with full canvas enclosure
-
Accommodations: 2 cabins (v-berth and bunk beds), separate head/shower, galley with fridge, sink, 3 burner princess stove, plenty of storage
-
Boat cruises at around 22 knots with top speed of 28 knots, burning around 15-20 gph
-
New Yanmars 6LYA-STP 370hp
-
New Cruz Pro Fuel gauge installed
-
New custom 6" side exhaust ports added
-
All new engine room vent hoses and blower hoses installed
-
All new system hoses installed for AC, Water, Bilge Pumps, Head, etc.
-
All new bronze sea strainers installed
-
All new Groco full-flow thru-hull ball valves installed
-
All new bilge pump thru hull fittings replaced
-
All new thru hull vent fittings replaced for head, water tank and fuel tank
-
All hull side air vents replaced and color matched to hull
-
New crash pump valves installed in-line with water intakes
-
Two new garboard hull drain plugs installed
-
New 25 gallon holding tank
-
New SMX Digital AC/Heat pump control
-
Entire bilge awlgripped white
-
New battery boxes
-
New 90 gallon water tank
-
New Reverso Oil change system for 2 engines, 2 transmissions, and generator
-
New engine room steps
-
All aluminum wire clamps throughout all bilges have been replaced with stainless steel clamps
-
4 new engine room lights installed to supplement existing single light
-
2 new water tank compartment lights installed
-
Two additional high capacity bilge pumps installed
-
Additional 110 outlets installed in cabin
-
New mini-blinds installed in cabin
-
Bennett Trim Tab indicators installed
-
New Amtico Teak & Holly Flooring installed in entire cabin in Fall of 2008
-
Boat wired for dockside cable
-
Custom thru-the-transom hawse plates added for dock lines to go thru transom
-
New 15" Flat Screen TV with DVD installed in V-berth
-
New 17" Flat Screen TV installed in Salon
-
New Stainless life-ring cockpit mount
-
Hard fiberglass top (aluminum frame) with full strataglass enclosure and bridge lighting
-
All new bridge cushions, helm cushions and cockpit coming
-
New Textaline black windshield cover
-
New V-Berth and Twin Bunk cushions and new covers
-
Swim Platform was re-awlgripped and new stainless support stanchions installed along with undermount, white rubber coated, stainless steel swim ladder
-
Rear cockpit was recored and awlgripped
-
Custom helm console was reconfigured for all new electronics and awlgripped
-
Windscreen frame and all grab rails were re-powdercoated
-
New tinted windscreens installed
-
Black and Gold boot stripes on 3 sides of bridge as well as dual stripes from bow to rear cabin sides re-awlgripped
-
Cockpit lights replaced, shorepower receptacles upgraded to stainless from plastic and new freshwater spigot replaced
-
New bridge cockpit lights
-
New matching 8' VHF antenna and 8' AM/FM antenna on new stainless mounts
-
New freshwater system circulating pump
-
New oak towel racks in bathroom
-
Three new bilge pumps
-
New bathroom blower
-
New Generator compartment blower
-
New Galley sink and Head faucets installed
-
New U-Line Refrigerator installed
-
New Shower sump pump with basin
-
New Fortress anchor
-
New "Bertram 33" Stainless Steel Insignias installed on both sides of cabin
Water heater was removed and A/C is currently not working.